Why Does Salt Melt Ice?
In short
Salt melts ice because dissolved salt lowers the temperature at which water freezes.[2][3] Dissolved in a film of water, it forms a brine that stays liquid below 0 °C and melts snow and ice.[1][2] Rock salt loses much of its effect below a pavement temperature of about 15 °F (−9 °C), where some agencies find it too slow.[1][2]

Key facts
- Practical lower limit for rock salt
- Pavement at 15–20 °F and above (MnDOT); about −9 °C (15 °F) for some agencies (FHWA); effective to 16 °F (Purdue Extension table)[1][2][4]
- Lowest freezing point of calcium chloride brine
- −51 °C (−60 °F)[1]
- Lowest freezing point of magnesium chloride brine
- About −33 °C (−28 °F)[1]
- Dissolved particles per formula unit
- Two for sodium chloride; three for calcium or magnesium chloride[3]
- Humidity at which it starts absorbing moisture from the air
- 42% for calcium chloride; 76% for sodium chloride[1]
- Urban streams with rising chloride (USGS, 2014)
- 84 percent of those analysed[5]
How does salt lower the freezing point of water?
A solution freezes at a lower temperature than the pure liquid, the effect used when salt, calcium chloride or urea is spread to melt ice on roads and sidewalks.[3] Chemists call this a colligative property: it depends on how many dissolved particles there are, not on what they are.[3] Sodium chloride splits into sodium ions and chloride ions as it dissolves, so each unit of salt adds up to two particles to the water.[3] When salty water freezes, only the water molecules join the solid, leaving the salt behind in the liquid.[3] The OpenStax chemistry textbook reports that a solution of 1 mole of salt per kilogram of water freezes 3.4 °C below pure water, less than complete splitting into two ions would predict.[3]
The more salt the brine holds, the lower its freezing point, but only down to a limit called the eutectic point.[1] For sodium chloride, that limit is a brine of 23 percent salt by weight, which freezes at about −21 °C (−6 °F); below that, no liquid brine can exist, only ice and solid salt.[1]
Why does salt need a little liquid water to start?
Salt can only lower a freezing point once it has dissolved.[1] A 1996 manual from the US Federal Highway Administration (FHWA) describes a dry grain of salt on a dry surface as simply sitting there until it draws enough heat from its surroundings for a thin liquid film to form on it; that first bit of brine then starts dissolving the rest of the grain.[1] For salt, dissolving is slow, and it takes in heat rather than giving it off.[1]
Water already on the pavement speeds this up, as does wetting the salt before it is spread, a step called prewetting.[1] The Minnesota Department of Transportation (MnDOT) says prewetting helps salt stick to the road and jump-starts melting.[2] Dry sodium chloride does not begin to pull moisture from the air until the relative humidity reaches 76 percent.[1]
Meltwater and rain dilute the brine, and once its freezing point rises above the pavement temperature, it freezes again.[1]
Why does rock salt stop working well in very cold weather?
Rock salt is sodium chloride in coarse crystals, made from the mined mineral halite.[4]
MnDOT puts the minimum practical range for salt at a pavement temperature of 15–20 °F (about −9 to −7 °C, by BodaWiki's conversion) and above, and says salt's effectiveness decreases significantly below 15 °F.[2] It also says salt can melt more than five times as much ice at 30 °F as at 20 °F.[2] The FHWA manual reports that some highway agencies consider salt impractical below −9 °C (15 °F), at least without calcium chloride, because it acts too slowly there.[1] A Purdue University Extension table lists sodium chloride as effective to 16 °F, though able to soften ice at lower temperatures.[4]
Chemicals also dissolve less as the temperature falls, and colder pavement needs a more concentrated brine: at −10 °C, a sodium chloride brine refreezes once diluted to about 13.5 percent.[1]
Why do calcium and magnesium chloride work at lower temperatures?
Calcium chloride and magnesium chloride each split into three particles when they dissolve, against two for sodium chloride, so they lower the freezing point further.[3] Their brines also stay liquid at much lower temperatures, and MnDOT says it starts adding them to its salt when temperatures drop.[1][2]
Calcium chloride also dissolves much faster than salt.[1] It pulls moisture from the air at a relative humidity of 42 percent or more and gives off considerable heat as it dissolves; mixed with rock salt, that moisture and heat help the salt dissolve faster.[1] Still, the FHWA manual finds that the two brines freeze in much the same way from 0 °C down to about −10 °C, or even −15 °C, and calls calcium chloride's lower floor unimportant for anti-icing.[1]
A Purdue Extension table, credited to the journal Stormwater, describes each chemical's limit in different terms:[1][4]
| De-icer | Lowest freezing point of its brine (FHWA) | Purdue Extension table, in its own words |
|---|---|---|
| Sodium chloride | About −21 °C (−6 °F)[1] | Effective to 16 °F; can soften ice at lower temperatures[4] |
| Calcium chloride | −51 °C (−60 °F)[1] | Melts ice to −25 °F; effective to −59 °F[4] |
| Magnesium chloride | About −33 °C (−28 °F)[1] | Lowest practical temperature: 5 °F[4] |
Where does the salt go after the ice melts?
The US Environmental Protection Agency (EPA) calls road salt a major source of sodium chloride to waterways and says too much salt in fresh water can harm aquatic life.[7]
In a study announced in December 2014, the US Geological Survey (USGS) found that chloride had risen substantially in 84 percent of the urban streams it analysed, in records from as early as 1960 to as late as 2011.[5] Twenty-nine percent of the sites exceeded the EPA's chronic water-quality criterion for chloride, 230 milligrams per litre, on more than 100 days a year on average from 2006 through 2011, almost double the number of days in 1990–1994.[5] In 13 streams, chloride also rose during periods without de-icing, such as summer, which the USGS said suggests that winter chloride soaks into groundwater and seeps back into streams all year.[5] Wastewater, septic systems and farming also add salt to US waters, but the study found de-icing to be the dominant source in urban areas of the northern United States.[5]
An earlier USGS report, from 2009, analysed 1991–2004 data from 1,329 wells in 19 northern states.[6] Chloride exceeded the EPA's secondary maximum contaminant level of 250 milligrams per litre in 2.5 percent of samples from shallow monitoring wells and 1.7 percent from drinking-water supply wells.[6] In monitoring wells, samples with more than 100 milligrams per litre of chloride and a high chloride-to-bromide ratio were dominated by halite, though they often also showed signs of sewage or animal waste.[6]
Frequently asked questions
Why is salt brine sprayed on roads before a storm?
The Minnesota Department of Transportation calls this anti-icing: a chemical is put on the road before a storm so that snow and ice cannot bond to the pavement.[2] It compares the practice to oiling a frying pan so food does not stick, and in many places it treats bridge decks the afternoon before a predicted frost.[2]
Can other dissolved substances melt ice too?
Yes. Freezing-point depression depends on the number of dissolved particles rather than on what they are, and de-icing schemes use salt, calcium chloride or urea to melt ice.[3] The same effect lets ethylene glycol work as antifreeze in car radiators; the OpenStax textbook notes that salts are unsuitable there because they speed up the corrosion of metal.[3]
What do road crews use when it is too cold for salt?
MnDOT says it starts adding calcium chloride or magnesium chloride to its salt at lower temperatures, and uses sand for traction when temperatures are very cold and chemicals will not work, or during freezing rain.[2] Sand does not melt ice, is easily pushed aside by traffic and brings its own environmental problems, such as air pollution and silt in waterways.[2]
Can road salt get into drinking water?
The EPA says salts can pollute drinking water sources and names road salt as a major source of sodium chloride to waterways.[7] A 2009 USGS report on the glacial aquifers of the northern United States found chloride above the EPA's secondary maximum contaminant level of 250 milligrams per litre in 1.7 percent of samples from drinking-water supply wells.[6] In shallow monitoring wells it found several sources of chloride; samples with more than 100 milligrams per litre of chloride and a high chloride-to-bromide ratio were dominated by halite, the mineral used in rock salt, though often mixed with signs of sewage or animal waste.[6][4]
Sources
- [1]Manual of Practice for an Effective Anti-Icing Program (FHWA-RD-95-202), Appendix B: Freezing-Point of Chemical Solutions · U.S. Department of Transportation, Federal Highway Administration · accessed October 8, 2026
- [2]Frequently Asked Questions (Maintenance) · Minnesota Department of Transportation (MnDOT) · accessed October 8, 2026
- [3]11.4 Colligative Properties (Chemistry 2e) · OpenStax (Rice University) · accessed October 8, 2026
- [4]Salt Damage in Landscape Plants (ID-412-W) · Purdue University Extension · accessed October 8, 2026
- [5]Urban Stream Contamination Increasing Rapidly Due to Road Salt (news release) · U.S. Geological Survey · accessed October 8, 2026
- [6]Chloride in Groundwater and Surface Water in Areas Underlain by the Glacial Aquifer System, Northern United States (Scientific Investigations Report 2009–5086) · U.S. Geological Survey · accessed October 8, 2026
- [7]EPA Researching the Impacts of Freshwater Salinization Syndrome (Science Matters) · U.S. Environmental Protection Agency · accessed October 8, 2026
Cite this article
- APA
- BodaWiki Editorial. (2026, October 12). Why Does Salt Melt Ice? BodaWiki. https://bodawiki.com/wiki/why-does-salt-melt-ice
- MLA
- “Why Does Salt Melt Ice?” BodaWiki, 12 Oct. 2026, bodawiki.com/wiki/why-does-salt-melt-ice.
- Chicago
- BodaWiki Editorial. “Why Does Salt Melt Ice?” BodaWiki. October 12, 2026. https://bodawiki.com/wiki/why-does-salt-melt-ice.