Technology

How Do Noise-Cancelling Headphones Work?

By BodaWiki EditorialPublished 4 min read

In short

Noise-cancelling headphones use microphones to sample outside noise and a processor that plays back a copy of it with its phase inverted, so the noise and this anti-noise cancel each other at the ear.[1][3][5] Active cancellation mainly tackles low-pitched sound (about 30 hertz to 1 kilohertz in a 1990 NASA report), while the ear cups passively block higher frequencies.[1]

A pair of black over-ear studio headphones with round ear cups and a coiled cable resting on a wooden table in soft daylight.
AI-generated illustration

Key facts

Principle
Play back the sampled noise with its phase inverted 180 degrees so the waves cancel[1][5]
Main range of active cancellation (1990 NASA report)
About 30 Hz to 1 kHz[1]
Main range of passive isolation (same report)
1 kHz to 20 kHz[1]
Combined reduction reported in 1990
Up to 20 dB at certain frequencies (one-hundredth of the noise power)[1]
Main designs
Feedforward, feedback and hybrid[3][4]
Paul Lueg's patent
Filed in Germany January 27, 1933; U.S. patent granted June 9, 1936[7]
Aircrew helmet system reported by Southampton University
1978[2]
Bose Aviation Headset introduced
1989 (called the first commercially available ANR system by Bose)[8]

Passive isolation vs active noise cancelling

Headphones can cut outside noise in two ways.[1] Passive attenuation absorbs or blocks sound on its way to the ear; in a headset, the ear cups and the materials they are made of do this job.[1][3] Active noise reduction (ANR), also called active noise control (ANC), instead samples the unwanted noise near the ear and plays back a copy of it with the phase of the signal inverted by 180 degrees.[1][3]

The two methods work on different parts of the sound spectrum.[1] A 1990 report prepared for NASA on helicopter pilots' helmets says active reduction mostly affects noise from about 30 hertz to 1 kilohertz, while passive attenuation has its greatest effect from 1 to 20 kilohertz.[1] Together, the report says, they can cut noise power by up to 20 decibels at certain frequencies, a reduction to one-hundredth of the power.[1] A perfect system would produce total silence, but the authors point out that pilots would not want that, because they listen to ambient sounds to check that the aircraft is working properly.[1]

How anti-noise cancels sound

A sound wave is made of regions where the air pressure is higher than atmospheric pressure and regions where it is lower.[5] When two waves meet, they interfere: if their amplitudes add, the sound gets louder, and if they are "out of phase" and subtract, the interference is called destructive.[5] That happens where the high-pressure part of one wave lines up with the low-pressure part of the other.[5]

Paul Lueg's patent, granted in the United States in 1936, describes the trick in plain terms: each time a "thickening" of the air reaches the microphone, the loudspeaker answers with a matching "thinning," and the other way round.[7] The two sound waves then "silence each other or dampen each other."[7] Engineers add a condition: for perfect cancellation, the anti-noise must match the noise in both phase and magnitude at a chosen spot, the "sweet spot."[3]

Inside the headphone: feedforward, feedback and hybrid

A typical design, described by signal-processing researchers at Helmut Schmidt University in Hamburg, uses two microphones.[3] One outside the ear cup picks up incoming noise slightly before it reaches the ear; an "error" microphone inside the cup measures what gets through.[3] A processor turns these signals into a control signal, inverts it and feeds it to the headphone's speaker.[3] Wanted audio, such as speech, is mixed in with the anti-noise signal, so it stays while the noise is reduced.[1]

Engineers sort designs by which microphone drives the anti-noise:[3]

DesignMicrophone usedStrengths and limits
FeedforwardOutside the ear cupHears noise early, but can cancel only noise related to what that microphone picks up, and the anti-noise must reach the inner microphone no later than the noise does[3]
FeedbackInside the ear cupWorks on the noise left at the ear, but in its basic form delays in the control loop limit how wide a range of frequencies it can cancel[3]
HybridBothCombines the two so that each partly makes up for the other's limits[3]

In a 2016 laboratory test of one headphone in an anechoic chamber, presented at the International Congress on Sound and Vibration, researchers found that feedforward worked better than feedback but was more sensitive to the direction the noise came from.[4] Their hybrid version did best, cutting noise by more than 20 decibels between 100 and 400 hertz and by 5 to 15 decibels between 500 and 800 hertz.[4]

Why low drones fade but voices get through

Active cancellation does its best work on low-pitched sound, from about 30 hertz to 1 kilohertz in the NASA report, and the ear cups' passive isolation handles most of the higher frequencies.[1] Timing is a key limit: delays in digital processing and in the sound's path through the headphone mean the anti-noise can reach the eardrum too late, so the system has to predict what is coming, a point made in a 2024 doctoral thesis at Aalborg University in Denmark.[6]

Speech is especially hard: the Aalborg thesis describes it as complex and "non-stationary," which makes it difficult to predict and therefore to cancel.[6] Fit matters too: the 1990 report notes that an ANR headset must seal properly against the head to stay stable, and that a broken seal can make the system break into a low-frequency oscillation the wearer can hear.[1]

A short history of noise cancelling

Paul Lueg of Germany applied for a patent in Germany on January 27, 1933, and in the United States on March 8, 1934, for a "process of silencing sound oscillations."[7] In it, a microphone picks up the sound and an amplifier and loudspeaker play it back with opposite phase.[7] The U.S. patent was granted on June 9, 1936.[7]

In 1978, researchers at Southampton University reported an active noise reduction system for aircrew flying helmets: a miniature microphone inside the ear defender picked up the noise, and an antiphase signal was fed back to the earphone.[2] In laboratory trials simulating flight, they judged its performance satisfactory.[2] The 1990 NASA report described U.S. Army tests of an ear-cup system developed by the Royal Aerospace Establishment in Farnborough, United Kingdom, and found that helicopter pilots understood speech significantly better with it switched on.[1]

According to Bose, as reported by the Aircraft Owners and Pilots Association (AOPA) in 2014, the company's research began after founder Amar Bose found on a 1978 flight that aircraft noise drowned out his music.[8] In 1986 its engineers learned of the planned Voyager flight, an attempt to fly around the world without refueling, and the flight team agreed to use Bose headsets.[8] The Bose Aviation Headset was introduced in 1989; a Bose vice president told AOPA it was "the first commercially available active noise reduction system in the world."[8]

Frequently asked questions

Do noise-cancelling headphones block all sound?

No. A 1990 report for NASA says active and passive methods together cut noise power by up to 20 decibels at certain frequencies, reducing noise significantly but not totally.[1] Active cancellation mainly affects low-pitched sound, and speech is especially hard to cancel.[1][6]

Why can I still hear voices with noise cancelling on?

Speech is complex and non-stationary, so it is hard to predict, and delays in processing mean the anti-noise can reach the ear too late, according to a 2024 doctoral thesis at Aalborg University.[6] In a 1990 NASA report, active cancellation also did most of its work below about 1 kilohertz, leaving higher frequencies mainly to the ear cups' passive isolation.[1]

What is the difference between feedforward and feedback noise cancelling?

Feedforward designs use a microphone outside the ear cup that hears noise before it reaches the ear, while feedback designs use a microphone inside the cup that measures the noise left at the ear.[3] Hybrid designs use both; in a 2016 laboratory test of one headphone, the hybrid performed best.[4]

How old is noise-cancelling technology?

The idea is decades old: Paul Lueg of Germany patented a method of silencing sound by playing it back in opposite phase; his U.S. patent was granted in 1936.[7] Southampton University researchers reported an active noise reduction system for aircrew helmets in 1978, and Bose introduced its aviation headset in 1989.[2][8]

Does the fit of noise-cancelling headphones matter?

Yes. The 1990 NASA report says an active noise reduction headset must keep a proper seal against the wearer's head to remain stable.[1] When the seal is broken, the system can go into a low-frequency oscillation that the wearer can hear.[1]

Sources

  1. [1]Comparison of Speech Intelligibility in Cockpit Noise Using SPH-4 Flight Helmet with and without Active Noise Reduction (NASA Contractor Report 177564, July 1990) · NASA Ames Research Center (NASA Technical Reports Server) · accessed October 8, 2026
  2. [2]An active noise reduction system for aircrew helmets · NASA Technical Reports Server (conference paper, Southampton University) · accessed October 8, 2026
  3. [3]Hybrid Active Noise Control Structures: A Short Overview · Helmut Schmidt University, Hamburg (Dept. of Signal Processing and Communications) · accessed October 8, 2026
  4. [4]Comparison of feedforward, feedback and hybrid structures on an ANC headphone (ICSV 2016) · University of Technology Sydney (OPUS repository) · accessed October 8, 2026
  5. [5]Interference of Sound · HyperPhysics, Georgia State University · accessed October 8, 2026
  6. [6]PhD Defence by Yurii Iotov: Speech Prediction-based Active Noise Control for Headphones · Aalborg University, Department of Electronic Systems · accessed October 8, 2026
  7. [7]US2043416A: Process of silencing sound oscillations (Paul Lueg) · Google Patents (U.S. Patent 2,043,416) · accessed October 8, 2026
  8. [8]Bose celebrates 25 years in aviation · Aircraft Owners and Pilots Association (AOPA) · accessed October 8, 2026
Cite this article
APA
BodaWiki Editorial. (2026, October 13). How Do Noise-Cancelling Headphones Work? BodaWiki. https://bodawiki.com/wiki/how-do-noise-cancelling-headphones-work
MLA
“How Do Noise-Cancelling Headphones Work?” BodaWiki, 13 Oct. 2026, bodawiki.com/wiki/how-do-noise-cancelling-headphones-work.
Chicago
BodaWiki Editorial. “How Do Noise-Cancelling Headphones Work?” BodaWiki. October 13, 2026. https://bodawiki.com/wiki/how-do-noise-cancelling-headphones-work.
  • headphones
  • active noise control
  • acoustics
  • sound waves
  • aviation